Ensuring Safety and Reliability: A Guide to Test Probe Kits and Compliance with IEC60065 Standard

I. Introduction:
Test Probe Knits are designed and manufactured in accordance with IEC60065 and GB4208 standards requirements. It simulate human hand in the IP protection test and mainly used in the figure one and additional letter A project of IP protection test. In the protection of persons against access to hazardous parts for IP1 code, A code test probe should test with 50±5N force.

Test Probe

II. Manual:
(1) Same as the below picture. The sphere should not access to live parts and hazardous parts.
(2) As the requirements in the protection of persons against access to hazardous parts test, the sphere should use with Push Pull and should trust 50±5N force in the protection surface.

SMT 065K

III. Attention：
(1)The sphere is weight, please pay much attention to prevent the falls of the sphere to damage to person or the sample.
(2)This sphere is made of bearing steel, please pay much attention to the regular maintenance and to prevent it rust.

Lisun Instruments Limited was found by LISUN GROUP in 2003. LISUN quality system has been strictly certified by ISO9001:2015. As a CIE Membership, LISUN products are designed based on CIE, IEC and other international or national standards. All products passed CE certificate and authenticated by the third party lab.

Our main products are Goniophotometer, Integrating Sphere, Spectroradiometer, Surge Generator, ESD Simulator Guns, EMI Receiver, EMC Test Equipment, Electrical Safety Tester, Environmental Chamber, Temperature Chamber, Climate Chamber, Thermal Chamber, Salt Spray Test, Dust Test Chamber, Waterproof Test, RoHS Test (EDXRF), Glow Wire Test and Needle Flame Test.

Please feel free to contact us if you need any support.
Tech Dep: Service@Lisungroup.com, Cell/WhatsApp:+8615317907381
Sales Dep: Sales@Lisungroup.com, Cell/WhatsApp:+8618117273997